| Last Modified: 11-29-2007 | 1.6 C | |
| Service Category: Suspension | Section: Tire Pressure Monitoring | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000026PN02FX |
| Title: TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
DTC |
C2176/76 |
Receiver Error |
DESCRIPTION
The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
C2176/76 |
Malfunction in the tire pressure warning ECU internal circuit. |
Tire pressure warning ECU |
INSPECTION PROCEDURE
NOTICE:
- When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
-
It is necessary to perform initialization
after registration
of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.
PROCEDURE
|
1. |
CLEAR DTC |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON and turn the Techstream on.
(d) Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
(e) Clear the DTCs.
|
|
2. |
CHECK FOR DTC |
HINT:
After clearing DTCs, turn the ignition switch off and ON once.
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON and turn the Techstream on.
(d) Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
(e) Check for DTCs.
Result
|
Result |
Proceed to |
|---|---|
|
DTC C2176/76 is not output. |
A |
|
DTC C2176/76 is output again. |
B |
|
|
|